Simulating a Trigger by Overload

<< Click to Display Table of Contents >>

 

Simulating a Trigger by Overload

After loading the initial scenario and a loading scenario, to simulate a trigger condition by overload, the Current Phase A of a device must be greater than the Current Limit of a Device for Self-Healing. To check these limits, click a device and select the Measurements option to open the window on the next figure.

Window with Analog Measurements of device SUB01.5201

Window with Analog Measurements of device SUB01.5201

An overload can be simulated by changing the Current Limit of a Device for Self-Healing option, so that this value is less than the value of the Current Phase A option. To do so, double-click the current's limit value, type a new value and then press ENTER. After the current limit condition is met, users must execute a command to proceed with the handling of this overload. To do so, click a device and select the Commands - Self-healing: Release handling trigger by overload - Turn on option.

Another possibility to simulate an overload is to change the loads of the system, as described on topic Simulating a Downstream Loading of a Device.

Was this page useful?