This Driver is already pre-configured with the next parameters:

•Physical Layer: Ethernet

•Protocol: TCP/IP

•Timeout: 1000 ms

•Port: 100

To perform any change on these settings, as well as to perform any other changes, click Configure driver on the Design tab of this Driver in Elipse E3, Elipse Power, or Elipse Water to open the configuration window.

On the Ethernet tab, configure a destination IP address in the IP option. The TCP/IP port to connect must remain configured as 100, which is the default for communication with Taktis, unless some configuration was changed on a device.

On the TaktisMCE tab, configure the communication parameters related to a device's communication protocol.