|
<< Click to Display Table of Contents >>
Preparing a Device |
For this Driver to receive messages, users must first configure the Watts SDK plug-in.
In the settings of this plug-in, add the IP address of the computer where this Driver is used on the list of allowed clients.
Also, map and assign an identifier to all Flux devices that send messages to this Driver. These devices are the following:
•Detectors
•Communication Detectors
•Groups of Detectors
•Scenarios
•Servers
•Zone Features
NOTE |
No mapping means no messages. When a mapping is not configured for a specific Detector, the Watts SDK plug-in does not send any messages from that device. |
This Driver supports Event identifiers when this feature is enabled in the Watts SDK plug-in. In this case, each Event has a unique identifier linked. This feature is optional and, when disabled, this Driver shows a NULL value for Event identifiers, and therefore users cannot use the REQUEST_CONFIRM_EVENT command.
More information about mapping and additional configurations can be found on the documentation of Flux SDK.